ApplianceJunk.com

Forum Index => Washer Repair => Topic started by: doxhunds3 on November 15, 2007, 05:59:45 PM

Title: Maytag washer A183
Post by: doxhunds3 on November 15, 2007, 05:59:45 PM
Would not agitate then started working, then stopped agitating again. Smells like rubber burning.  Black pieces of burnt belt or something underneath it. It spins and pumps fine. Its makeing a noise now. I just ordered a set of belts, I hope I can figure out how to install them.
Title: Re: Maytag washer A183
Post by: rickgburton on November 15, 2007, 07:37:56 PM
Lean the washer back so you can access the main pulley. Remove the belts. Turn the pulley by hand in both directions. One way is spin the other is agitate. Then check pump pulley and motor pulley.
Title: Re: Maytag washer A183
Post by: AJ on November 15, 2007, 07:47:38 PM
Quote
I just ordered a set of belts, I hope I can figure out how to install them.

Video: Replace Belts on Maytag Dependable Care Washer (http://appliancejunk.com/forums/index.php?topic=220.0)