ApplianceJunk.com

Forum Index => Washer Repair => Topic started by: Tim Buchinger on August 09, 2013, 02:32:24 PM

Title: Issue reassembling a Kenmore 90 Series
Post by: Tim Buchinger on August 09, 2013, 02:32:24 PM
I have a Kenmore 90 series that I had to replace the clutch on. The replacement of the clutch went well however I found this pin lying on the ground under the machine when I went to put everything back together and I cannot for the life of me figure out where it goes! I should have taken a picture with a tape measure beside it to better illustrate the size but its probably about 2-3 inches in length.

Any ideas?

http://s7.postimg.org/h0p8yrm9n/Washer_Pin.jpg (http://s7.postimg.org/h0p8yrm9n/Washer_Pin.jpg)
Title: Re: Issue reassembling a Kenmore 90 Series
Post by: dab147315 on August 09, 2013, 02:59:11 PM
Thats a shipping pin.You don,t need it.
Title: Re: Issue reassembling a Kenmore 90 Series
Post by: Tim Buchinger on August 09, 2013, 03:27:55 PM
Well that makes me feel a lot better, thank you very much for the help.
Title: Re: Issue reassembling a Kenmore 90 Series
Post by: AppTek on August 09, 2013, 04:35:33 PM
I know a mechanic that found those pins and welded them in place lol. He didn't know why the washer shook so bad when he was done... :rofl:  :oops: