ApplianceJunk.com

Forum Index => Washer Repair => Topic started by: pallanesfour on July 30, 2012, 01:01:25 PM

Title: calypso washer 10653606201
Post by: pallanesfour on July 30, 2012, 01:01:25 PM
fault code is C E how would i go about diognoseing this code :D
Title: Re: calypso washer 10653606201
Post by: bigbuck on July 30, 2012, 01:26:03 PM
Need correct mod number, model number you have listed is for refrigerator.

Sent from my MB865 using Tapatalk 2
Title: Re: calypso washer 10653606201
Post by: pallanesfour on July 30, 2012, 01:32:03 PM
110.22082102
Title: Re: calypso washer 10653606201
Post by: AJ on July 30, 2012, 01:39:59 PM
Here you go...

I have also attached a copy of the tech sheet for you. Please update us at to what you find wrong.

CE=Communications Error

If there is any breakdown in communication between the machine controller and the motor controller, “CE” flashes and the unit beeps once. Units with repeated CE errors may be diagnosed as follows:

NOTE: Disconnect power before performing any checks. Serial Communication Checks:

■ CheckforcontaminationonP4ofthemachinecontrollerand P2 of the motor controller. If contaminants exist, disconnect power to the unit and gently scrape any contaminant off
the pins.

■ Check the resistance values between the serial communication pins with the connectors in place (resistance reading should be less than 10 ohms). Make sure the harness is connected properly.

■ After ensuring integrity of this connection, run the unit again to see if problem still exists. If so, continue with Control Checks.
Control Checks:

■ Check motor winding resistance at P6 of the motor controller (in the console). If an open circuit is found, this is an indication of problems with connections to the drive motor or the motor itself. See Drive Motor Checks.

■ If winding resistance is correct, check motor controller fuse; if open, replace motor controller.
Drive Motor Checks:

■ Check connection of the lower harness to the drive motor and pump motor.

■ Check if the drive motor thermal protector has opened.


Title: Re: calypso washer 10653606201
Post by: JWWebster on July 30, 2012, 05:27:46 PM
Might be corrosion on the harness between the motor and the control upstairs. Unplug and reconnect everything. Press stop/cancel to clear the error after checking the connections.
Title: Re: calypso washer 10653606201
Post by: pallanesfour on August 03, 2012, 02:39:16 PM
this download was the bomb it was the board  O0 :2funny: :rofl:
Title: Re: calypso washer 10653606201
Post by: AJ on August 03, 2012, 02:55:53 PM
Glad you found the download helpful.

Thanks for the update.  O0