ApplianceJunk.com

Forum Index => Washer Repair => Topic started by: zwingli on June 19, 2012, 08:27:42 PM

Title: Duet wfw8300sw05
Post by: zwingli on June 19, 2012, 08:27:42 PM
I replaced the control board (not the MCU) in this machine. The display was flickering and the machine would stop in mid load. It did not set any codes . After replacing the board and powering up it worked for a few loads and then started acting up. The diagnostics do not work and it doesn't set any codes. It starts a load and the minutes on the timer will go back and forth between the time and 8. The display will start flickering and then the machine will shut down. I did all the component checks in the tech sheet and everything checks out. I didn't check the motor though.
Any help would be appreciated.
Thanks.

wfw8300sw05